 |
05-08-2001, 12:07 AM
| #1 (permalink) |
| Join Date: May 7 2001
Posts: 2
Rep Power: 0  | I was setting the address on my T-max 3a, that was successful. Then I was trying to exit the parameters by pushing the up and down arrows, it is now stuck with a 39 showing. I removed power to try to reset. It didn't work. What do I do? |
|  |
|
05-08-2001, 11:31 AM
| #3 (permalink) |
| Join Date: May 7 2001
Posts: 2
Rep Power: 0 | Quote:Originally posted by Kevin Barrett:Your timer is setting at address 0. Is it connected in a daisy chain to a T-Max Manager or are controlling another digital timer in the tanning room?Kevin BarrettADI Tech Supportkevin,Yes, the timer is setting at 0. No, at the time I was setting it up as the controlling unit to operate the 3a in the tanning room, (which is set on .1). The instructions say to not have them daisy chained when setting both units. Also the unit is beeping while it is showing 39, it beeps 16 times and then the 39 flashes off once and then starts over again. Thanks Mike |
|
| |
|
05-09-2001, 07:52 AM
| #4 (permalink) |
 Join Date: Jan 26 2000 Location: Branson West, MO Age: 58
Posts: 210
Rep Power: 25 | Once you connect it to the T-Max 3A in the tanning room the timer at the front desk should go to a 0. If not, make sure the timer in the tanning room is set to address 1 not 101 (no flashing period when you check the address) then check your cable connections.Kevin BarrettADI Tech Support |
|
| |
 |
| Bookmarks |
« Previous Thread
|
Next Thread »
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| |
All times are GMT -5. The time now is 04:05 AM.
