tanTALK - Tanning Salon Business Owners Community

tanTALK - Tanning Salon Business Owners Community (http://tantalk.com/)
-   Technology Forum (http://tantalk.com/technology-forum/)
-   -   lamps wont turn off!!!! (http://tantalk.com/technology-forum/2382852-lamps-wont-turn-off.html)

zoomtan 03-30-2010 02:21 PM

lamps wont turn off!!!!
 
this just happend today one of our stand-up beds a 48 tube sunquest aurora 160w ballast with 225w tubes

its been working fine for 8 months the sudenly today
my wife noticed after the fan had gone off and the session finnished the lamps remain on, cant turn them off unless by the main safty switch at the back of the room. this bed is out of action untill we sort this out any know where to start looking.

we have a freindly electrician but hes not familiar with sunbeds.
is there any ideas i can give to start looking for.

tried resetting the coin box, then putting in a token but time starts fan comes on session finishes fan goes off but lamps still stay on.
regards
mika

Robert K 03-30-2010 02:58 PM

Re: lamps wont turn off!!!!
 
a 160w ballast with 225w tubes?

Anyway when you turn the disconnect back on does the bed start right up again or do you have to put a token in?

zoomtan 03-30-2010 03:43 PM

Re: lamps wont turn off!!!!
 
Quote:

Originally Posted by Robert K (Post 15032493)
a 160w ballast with 225w tubes?

Anyway when you turn the disconnect back on does the bed start right up again or do you have to put a token in?

thanks robert, i enjoy reading your comments,
yeah i know, thats how i got it, and thats how the sunbed warehouse sold it to the guy i bought it from, i gues from what i think i know now, that its only burning at 160w so does this affect life of lamp?

any way no you dont have to put a token in it just lights up with no fan running, its only when you put a token in that the fan comes on.

Robert K 03-30-2010 05:52 PM

Re: lamps wont turn off!!!!
 
Sounds like you main contactor may be stuck.

zoomtan 03-31-2010 05:58 AM

Re: lamps wont turn off!!!!
 
Quote:

Originally Posted by Robert K (Post 15032506)
Sounds like you main contactor may be stuck.

is that like the main breaker? where would that be and what does it look like.

ok had a look theres a grey plastic type block wich has diagram of switches on in a housing to protect it.
cheers
mika

Robert K 03-31-2010 03:33 PM

Re: lamps wont turn off!!!!
 
The contactor is the square peice with a lot of wire going in and out off. When the unit is turned on the contactor pulls in and makes contact thus allowing power to go through and power on the lamps. Contactors can get stuck and not release. Try tapping it with the backside of a hammer or screw driver. Make sure the power is off.

zoomtan 03-31-2010 03:44 PM

Re: lamps wont turn off!!!!
 
thanks for the help robert, this all makes sence, so will try that tomorrow, will also look to see if any wires loose, electrician is comming in the morning. i do have a spare actually we a problem with this bed when we bought it, it turned out then to be a pcb board in the token box, but we bought a replacement contactor in case that was the problem, so i hope its all to do with the contactor, will let you know tomorrow
mika

zoomtan 04-01-2010 09:51 AM

Re: lamps wont turn off!!!!
 
thanks every one one tap with a hammer and back working as normal, will change the contactor box though
cheers
mika


All times are GMT -5. The time now is 08:15 AM.

Powered by vBulletin® Version 3.7.2
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
LinkBacks Enabled by vBSEO 3.1.0
Copyright 2009 - tanTALK.com