T-Max Manager/Plus Info

[Neon Beach]

Programing for the Manager/Plus

1. Adress all 1-A,2-A,3-A'S

2. Hook up all RJ-22's to all your timers

3. Apply power to the Manger/plus

4. Press the call/menue key, the display will read SECURITY/CALL

5. Enter security level 3333 and press the enter key

6. The display will now read GET PARAMS, press the next key

7. The display will now read SEND PARAMS, press the next key again.

8. The display will now read MGR PARAMS, Press the enter key

9.The display will now read MGR DELAY enter the desired delay time. If you want a 3 minute delay before starting enter 3, or 5 if you five min. delay. Mine are all set for 10

10. The display will now read MGR START MODE, enter the desired Auto start funtion.
0 = the tanning bed will not energize when the delay time expires,but session time will start counting down.

1 = The tanning bed will energize as soon as the delay time expires, unless the delayed time is bypassed.

2 = The MGR/PLUS goes into infinite delay the tanning bed will not energize until the start button is pressed.NOTE: this feature will not work on units "98" OR OLDER.

11. The display will now read MGR MAX BED enter the highest address in the salon. If you have 10 units you must enter 10, press the enter key.
(personally I always add 2 extra.)

12. The display will now read MANAGER NUM enter the manager address followed by the enter key
This funtion is used only if you are hooking up more than one MANG/PLUS If you are using just 1 MANG/PLUS just press the enter key with out entering a number.

13. The display will now read MGR RE-SCAN TIME Press the enter key.(without entering a number)

14. The display will now read MAX SLAVE This number should be equal to the manager(if you only have one manager in the salon just press the enter key without entering a number.

15. The display will now read SAVING PARAMS Do not press any keys just let the MGR/Plus save the params and re-scan for the beds. After the MGR/Plus is done saving the display will read BED 1 READY. Programing is now complete.

I posted this because spring is coming and some time during storms and power failure's you may loose your programing. If this should happen to you............ start with #4

Thanks Bob.