Versaspa help Yesterday I cleaned the spray nozzles on the Versaspa and now the bronzer seems to be beading up on the customers. Any help would be appreciated. I have cleaned the many times before and have never had this problem. |
Re: Versaspa help could be pump or clog head, pin hole in line. look at hose when pumping, from motor end in back when opening drawer. |
Re: Versaspa help When is the last time you calibrated? check that as well. |
Re: Versaspa help I weighed the solution yesterday and it was using 90 grams for dark. It almost seems like water is mixed in the bronzer. I'll look for a pin hole in the line. It's really weird because it worked fine and all I did is clean the nozzles and put them back in. |
Re: Versaspa help Quote:
Are the vanes around your nozzles up and down or did you put them back on side to side? |
Re: Versaspa help Ken, They were side to side instead of up and down. I'm going to give that a try when I get back to the salon. Thanks Terry |
Re: Versaspa help The air holes being at 3 and 9 instead of 12 and 6 will not make the solution bead up, it will give you a horrible spray pattern more like a stripe up and down instead of even. |
Re: Versaspa help The nozzles being in the wrong position was the problem. Sometimes you just miss the small things. Thanks for all the input. |
All times are GMT -5. The time now is 03:25 PM. |
Powered by vBulletin® Version 3.7.2
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
LinkBacks Enabled by vBSEO 3.1.0
Copyright 2009 - tanTALK.com