bgviper76

Hey Everyone,

I have a My Myst that is giving me some problems. It leaves about 1/3 of the solution in the cartridge, even after the purge cycle.

I didn't understand what my staff was complaining about, because I went and tested it, and was using cartridges with water, and the water sprays great and the cartridge is just about empty at the end of the purge.

I finally used a few actual cartridges and saw what they were talking about. I guess the consistency of the solution is a lot different than water, causing the issue.

I took the whole spray housing apart, and all of the tubes, and barbs, and connections related to the solution, and all was clean. I was able to blow air through all of them, and I could see right through the straight connections.

The cycle time is 15 seconds from top to bottom, and bottom to top. Running pressure is right about 45. I tried increasing a little, but that didn't help either.

It sputters with solution, but sprays great with water. Even when not sputtering, it leaves this extra solution. Customers are not pleased, so I have left the unit down.

Any advice would be greatly appreciated.

Thank you

socaltech

If you have cleaned it all including the puncture tube assembly then you have a solution solenoid not opening up all the way. There are a few tricks to get this machine cleaned up but that solenoid acts up . Remove the flow disc and see it allows more solution to flow

__________________
www.SoCalTechnicians.com
California Tanning Bed Technicians
310-418-1519

tpc tan man

YOU NEED TO BACK PURGE THE UNIT YOU CAN DO THIS BY TURNING UP YOUR AIR PRESSER AND HOLDING A TOWEL OVER NOZZLE AND HIT THE PURGE BUTTON TRY THIS A COUPLE OF TIMES MOST OF THE TIME THIS WORKS.OTHERWISE YOU MY NEED A NEW NHA