02-26-2016, 09:05 AM | #3 (permalink) |
Join Date: May 7 2005 Location: North Carolina
Posts: 151
Rep Power: 19 | Re: Ergoline Avantagrde Manuals Thanks. Does anyone have the diagram for this bed to go to/from 3 phase/single phase? Is it the same as the 450 Classic? I have contacted JK but haven't heard back yet. Last edited by beachbumz; 02-26-2016 at 05:14 PM. |
02-29-2016, 09:21 AM | #6 (permalink) |
Join Date: May 7 2005 Location: North Carolina
Posts: 151
Rep Power: 19 | Re: Ergoline Avantagrde Manuals I know how to wire the neutrals to each phase and vice versa to go to/from 3-phase. Problem with this one is that the "distributor" changed the wiring at the main contactor inside the electrical housing instead of at the terminal block where the power enters the bed to go to single phase. Most of the wires were still factory stamped to get them straightened back out to 3-phase. I just wanted to verify I had everything correct before testing. Typically I would connect L1-N3, L2-N1 and L3-N2 for 3-phase. However, the schematic and wire stamps show this to be wired as L1-N1, L2-N2 and L3-N3. Can this be correct? If anyone just has a photo of the contactor area, that would be a big help. Last edited by beachbumz; 02-29-2016 at 09:27 AM. |
Bookmarks |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| |
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Looking for manuals | Midnightstar | Tanning Equipment | 0 | 12-20-2013 06:31 PM |
Manuals | 114SunSpa | Looking for a Part? | 3 | 02-29-2012 08:02 AM |
manuals | blonde2benvied | Wanted | 4 | 06-01-2009 06:11 PM |
Equipment Manuals???? | Tropical Dreams | Tanning Equipment | 2 | 01-29-2009 01:40 PM |
Help Manuals Needed | Kagha | General Tanning Industry Discussions | 1 | 12-01-2008 07:49 AM |