ETS FACIALS BULBS KEEP BLOWING

[Cindie]

have several ETS tanning beds .. we have to replace the Facial Bulbs weekly and some times the whole ceramic facial bulb holder.. Does any one know why this keeps happening ?

[JOHN @ URI]

Change the ignitors.

Once a lamp gets burned up in those sockets you usually need to replace the socket also, or it will just keep happening.

[Cindie]

are you talking a bout the ceramic bulb holders ?

[tanu01]

Your most likly over powering the bed. Check your voltage. And as John said, if the socket gets burnt you'll have to change both lamp and socket.

For a lamp to last a week in a bad socket/lamp holder is pretty good.

[tantech1985]

Always look at both lampholders before inserting a new lamp. If they are black at all, change them. If your voltage is over 230 the lamps will not last long. Are all the fans above the facials working. They may look like they are turning but are they at full speed? This is a common issue with these units. After a few years these lampholders will start to get old and burn up. You should always have some on hand. I ussually change both if one burns out.