2005 ETS 755 Sunscape: 2 of 5 Facials not coming on - Page 2 - tanTALK

suncitypembroke · 04-10-2013, 01:22 AM

Like brian say use good lamp that what I am going with.

rowlandc · 04-20-2013, 07:54 PM

Okay, found out today that the two bed cooling blowers in the right pedestal are not coming on, which would explain the heat problem. Body cooling blower in the left pedestal and the three exhaust fans are running. Didn't have time today but will open ballast tray tomorrow to check the problem.

tantech1985 · 04-26-2013, 08:02 AM

There is a fan relay at the rear of the bench ballast tray. Should have an orange wire on the coil from the timer. Then it loops to a distribion block. Likely the relay is bad or a wire has burnt off somewhere in that area. I douby both blowers would go bad at the same time.

rowlandc · 04-26-2013, 09:04 PM

Ok, after checking the voltage in the bench ballast and everything getting power as it should, I went to the pain of lifting up the bench to get to the bed cooling blowers. Found two fan wires had obviously been sucked into the fan and were cut. (No one but myself to blame since I put the bed together and didn't secure the wires!) Put them back together and everything now working as it should. Facials no longer going out.

woehrle · 04-28-2013, 04:46 PM

04-10-2013, 01:22 AM	#11 (permalink)
suncitypembroke Join Date: Apr 21 2004 Location: Mass. Posts: 698 Rep Power: 21	Re: 2005 ETS 755 Sunscape: 2 of 5 Facials not coming on Like brian say use good lamp that what I am going with. Last edited by Robert K; 04-10-2013 at 07:23 AM.

04-20-2013, 07:54 PM	#12 (permalink)
rowlandc Join Date: Aug 21 2010 Location: Dublin, GA 31021 Posts: 39 Rep Power: 0	Re: 2005 ETS 755 Sunscape: 2 of 5 Facials not coming on Okay, found out today that the two bed cooling blowers in the right pedestal are not coming on, which would explain the heat problem. Body cooling blower in the left pedestal and the three exhaust fans are running. Didn't have time today but will open ballast tray tomorrow to check the problem.

04-26-2013, 08:02 AM	#13 (permalink)
tantech1985 Join Date: May 2 2011 Location: midwest Posts: 93 Rep Power: 0	Re: 2005 ETS 755 Sunscape: 2 of 5 Facials not coming on There is a fan relay at the rear of the bench ballast tray. Should have an orange wire on the coil from the timer. Then it loops to a distribion block. Likely the relay is bad or a wire has burnt off somewhere in that area. I douby both blowers would go bad at the same time.

04-26-2013, 09:04 PM	#14 (permalink)
rowlandc Join Date: Aug 21 2010 Location: Dublin, GA 31021 Posts: 39 Rep Power: 0	Re: 2005 ETS 755 Sunscape: 2 of 5 Facials not coming on Ok, after checking the voltage in the bench ballast and everything getting power as it should, I went to the pain of lifting up the bench to get to the bed cooling blowers. Found two fan wires had obviously been sucked into the fan and were cut. (No one but myself to blame since I put the bed together and didn't secure the wires!) Put them back together and everything now working as it should. Facials no longer going out.

04-28-2013, 04:46 PM	#15 (permalink)
woehrle Join Date: Jan 11 2011 Location: Avon Indiana Posts: 24 Rep Power: 0	Re: 2005 ETS 755 Sunscape: 2 of 5 Facials not coming on ok Last edited by woehrle; 04-28-2013 at 06:03 PM. Reason: problem was resolved

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
For Sale 2005 Soltron Kiss no facials	joenba1k	For Sale - FOR SALON OWNERS ONLY	0	09-26-2009 02:52 PM
3 2001 Puretan 33's, 2005 VHR Bed, 2005 Miracle Mist Spray, Formostar Body Wrap	balltan	For Sale - FOR SALON OWNERS ONLY	8	03-05-2007 07:24 PM
? Sunscape	yoco	Tanning Equipment	8	05-18-2006 06:59 AM
Sunscape	yoco	Tanning Equipment	22	04-06-2006 09:49 PM
sunscape	madalyn	General Tanning Industry Discussions	0	12-06-2004 11:38 PM