mufasa_keoposa

WE CONECTED THE WIRES THAT WERE DISCONECTED FROM THE BASE TRAY FOR MOVING IT CONECT THE POWER PLUGGED IT IN AND NOTHING THERE IS A BUTTON ON THE BASE TRAY WE PRESSED IT AND IT BEEPED AND THE LITTLE DOT LIGHT IN THE TIMER DISPAY WENT ON BUT WHEN WE LET GO IT GOES OFF NO NUMBERS NO ER READING JUST THAT LITTLE DOT LIGHT. I HAVE NO IDEA IF THE BED IS MISSING THE PIECE THAT YOU HAVE TO PLUG IN TO USE IT AS YOU PLEASE OR DO I NEED TO CONNECT IT TO THE SALON TIMER SET UP THAT CAME WITH THE BED THE PEOPLE I GOT IT FROM WERE OF NO HELP. HELP!!!!!!!!!!!!!!!
I ALSO NEED A MANUAL TO THE BED OR A COPY IF ANY ONE HAS ONE OR CAN COPY ONE FOR ME THAT WOULD BE GREAT!!!!!!!!!!!!!
YEAR OF THE BED 1995

Sarge

The button is a safety switch on the ballast tray, you can either by pass it or make sure you have the cover on it. This bed was set up most likely for running on a remote timer, if your going to run it on the bed timer you need to have the by pass plug but in, looks like a speaker jack on this bed. Then you need to program the timer itself to run on stand alone. PM me and I can fax over the program manual. It's kinda a pain in the azz to do. You will need to be able to unplug the power while holding in a couple of buttons during your programing.

mufasa_keoposa

THANKS A MILLION RUNNING GREAT!!!!!!!!!!!!!!!

Sarge

Good the hear it worked out.