brookwbc

We have an ETS bed with 3 facials and 1 of the facials was flickering. We replaced the lamp in that facial.

We turned this bed on this weekend and the facial lamps come on as soon as the bed starts. This is a 15 min. bed and when the timer gets to 9 mins the 1 facial turns off. It stays off for 2 mins and comes back on. Every 2 mins. it's turning on and off. Could this still be an ignitor problem?

engfant

Heat homey. That's what they do when it's heat related. They shut off, then turn on when the heat lowers enough.

__________________


Nothing is more dangerous than stupid.

The #1 cause of death is natural causes...but where's the ribbon?

http://mercola.fileburst.com/Flash/A...wsubscribe.swf

Renaissance

^ What he said... The fan that is cooling down that facial is not working properly so as the bed runs a few sessions back to back it cannot cool it properly so it shuts off...

__________________
"entrepreneurship is living a few years of your life like most people won't, so that you can spend the rest of your life like most people can't."

tmmacav4

Im with them its a fan, we had the same thing happen.

brookwbc

Is this difficult to fix? I'm not familiar with working on these beds.

engfant

You have to figure out what's causing the overheating. IF all the fans are running fine, then maybe the bed is starved of air?

I'd say try adding a small fan to the front of the bed that blasts the facials.

__________________


Nothing is more dangerous than stupid.

The #1 cause of death is natural causes...but where's the ribbon?

http://mercola.fileburst.com/Flash/A...wsubscribe.swf

brookwbc

How do I check the fans? Sorry but I told you I'm not familiar with these beds.

engfant

Just look for them. They have to be somewhat exposed somewhere around the lamps. Look in vents, etc for a sluggish fan and or dust build up. Or just lightly touch the facial glass after it goes out. If your finger melts to the glass, you got a heat problem.

But if it's heat releated just add a small fan to the area and aim at the facial area. Even start the bed, let it run and put the fan where your head would go and aim the fan straight up to the facial.

If it's heat related then that would be enough to keep it from OVERheating.

__________________


Nothing is more dangerous than stupid.

The #1 cause of death is natural causes...but where's the ribbon?

http://mercola.fileburst.com/Flash/A...wsubscribe.swf

brookwbc

Ok. I checked the fans last night on this bed and the fan over the facial that is going on & off is not coming on. Is it difficult to replace the fan? Where's a good place to buy a replacement fan?

Sarge

Bad thermo if your fans are working correct or its just way to hot in the room, but if only one facial is giving you the issue and the fans are working then I would change the thermo.