tanTALK - Tanning Salon Business Owners Community

tanTALK - Tanning Salon Business Owners Community (http://tantalk.com/)
-   Canadian Forum (http://tantalk.com/canadian-forum/)
-   -   New at this need help please (http://tantalk.com/canadian-forum/2390474-new-need-help-please.html)

Donymca 11-20-2012 09:33 AM

New at this need help please
 
Hi we have a sunstar zx30 tanning bed and a t-max 3a timer and i would like to set it up so our front desk can run the timer have tryed to get it to work by the instructions but can't get it to work do not have a t-max manager can it work with just the 3a or am i fighting a losing battle
Don

Brian Oshman 11-20-2012 06:38 PM

Re: New at this need help please
 
Set the address on the 3a to zero ans the bed to one.

Donymca 11-21-2012 11:01 AM

Re: New at this need help please
 
did that still will not work

Donymca 11-23-2012 03:30 PM

Re: New at this need help please
 
Set the tmax at address 0 and the bed at 1 but when i try to use the remote it shows the nu 38 and will not go to 0 to be able to set time it flashes to 8 for a sec then back to 38 if i change the address on tmax to anything else seems to work but not on 0
Thanks for any help
Don

Brian Oshman 11-23-2012 09:12 PM

Re: New at this need help please
 
Probably have a bad comm chip in the bed or the timer.


All times are GMT -5. The time now is 12:49 AM.

Powered by vBulletin® Version 3.7.2
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
LinkBacks Enabled by vBSEO 3.1.0
Copyright 2009 - tanTALK.com