tanTALK - View Single Post

RCKnep3 · 03-30-2008, 03:32 PM

Ok, I'm sitting here lost. I'm usually good at these type things. I had someone give me 4 1a timers. I already have a T-max manager pro for 1 bed (timer built in). I am trying to get these set up....can someone give me a hint???? OK, I am just trying to set up the 1st one to make sure I have it straight, I don't care that I will need to reprogram again once I have them all done. I have the correct line run from the manager to the 1a in the 1st room. I have the correct wire run from the 1a to my bed, I have reprogrammed my bed to be controled remotely....so I should be all set? Problem is the 1a display says 11 and will not change no matter what I try? I tried the other 3 too and they also do they same. Per tmax manual they should read 99. When I try to address the beds, it picks up an address for that 1a but will not do anything. HELP PLEASE. I want to do this today.

03-30-2008, 03:32 PM	#1 (permalink)
RCKnep3 Join Date: Feb 23 2008 Location: Slippery Rock, PA Posts: 82 Rep Power: 0	Tmax 1a help Ok, I'm sitting here lost. I'm usually good at these type things. I had someone give me 4 1a timers. I already have a T-max manager pro for 1 bed (timer built in). I am trying to get these set up....can someone give me a hint???? OK, I am just trying to set up the 1st one to make sure I have it straight, I don't care that I will need to reprogram again once I have them all done. I have the correct line run from the manager to the 1a in the 1st room. I have the correct wire run from the 1a to my bed, I have reprogrammed my bed to be controled remotely....so I should be all set? Problem is the 1a display says 11 and will not change no matter what I try? I tried the other 3 too and they also do they same. Per tmax manual they should read 99. When I try to address the beds, it picks up an address for that 1a but will not do anything. HELP PLEASE. I want to do this today.